5. Insert the paper end into the receipt inlet behind
the printer. Then, manually feed the paper into
the printer while pressing the [RF] key until about
4 inches (about 10cm) of paper comes out of the
printer.
6. First pass the paper through the Receipt Outlet of
the Printer Cover, then attach the Printer Cover.
After that, depress the [#/NS] key to check the
print condition and cut the paper with the cutter.
CAUTION: Be sure to attach the Printer Cover to
the Top Cover tightly.
NOTE: E22 error is released by the [C] key.
1. When replacing the journal, depress the [JF] key
to wind up the enough Journal Paper, then cut
the paper at the arrow indicating position in the
figure on the left. Press down the [JF] key to
take away the cut paper.
CAUTION: Never try to pull out the remaining
paper end by hand. It may cause a
paper jam
2. Remove the Journal Take-up Reel Ass’y from the
holder, then remove the Support Plate (c) to pull
the paper out of the reel (d).
3. Follow Steps 3 to 5 of “Installing/Replacing the
Receipt Roll” except that the paper roll should be
placed right holder and the [JF] key should be
used for the journal roll to advance about 8
inches (20 cm) of paper out of the printer.
RF
#/NS
JF
X/TIME
987
C
To Next Page
Loading...
Need help?
General
