Up_Time – This field gives an indication of how much time has elapsed since the card was last
rebooted or powered up.
Upgrade – By checking this box for a particular card, you will make each of the fields at the
bottom of the screen active for that card. This allows you to upgrade multiple cards at a time.
Figure 46 below shows in detail the upgrade section available on the PairingInfo page.
Following is a brief description of the relevant fields on this page:
Usage - This field allows you to select which type of file transfer you wish to undertake for a
particular card. The available options are shown below. It should be noted that when selecting
any option other than ‘2’, the card will appear to go through the usual software update cycle, but
that it will revert to the current build of code once it has rebooted.
0 = Set_Log_IP – This option allows you to identify the IP address to which you wish to
send COM51 logging for monitoring by a syslog utility.
1= MT – This option allows upload of Mediatune channel files.
2= SW_Upgrade – This is one of two means of updating the software in a COM51 card.
3= Log – This option allows you to copy a COM51 card’s internal log files to a PC.
To Next Page
Loading...
Need help?
General
