33.3 Adding Welcome Screens to Guide Data
Welcome screens should be included in EPG /IPG programming to facilitate channel mapping
and inclusion in EPG / IPG guides.
➢ Enter the welcome screen channel and mapping information into the guide as if it was any other
external source being modulated by the QAM20.
➢ Log into the COM51 card running EPG and add the channel to the EPG information as shown in
Figure 65.
Figure 65 - Adding Welcome Screen to EPG and PSIP
You can verify the screens are streaming by checking for data on the corresponding QAM port as
shown in Figure 66 below.
Figure 66 - Verify Welcome screen is streaming
33.4 Disabling Welcome Screens
➢ To disable the Welcome screens set the Mode field to 0.
➢ Click Submit.
➢ Reboot card.
To Next Page
Loading...
Need help?
General
