Technogym D847M - Switching On and Off

31
中文
日本語
Br Es Nl De Fr It
Uk
user manual
18 Switching on and off
03056007


In this mode, the following functions are enabled:
- calculation of heart rate, if measured;
- reading of access codes for configuration menu (see the Configuration Menu
section in the software part);
- change of gradient.
To turn the equipment on, switch the
switch to the “ON” position (I).
The ON (I) / OFF (0) positions may vary
according to the equipment version. The
correct positions are given on the label
on the equipment.
When switched on, a beep sounds and
all the control panel LEDs light up.
After a quick system check (reset), the
equipment is ready for use.
The message does not appear if the
keys are disabled (see the Configuration
Menu section in the software part) so
that exercises can be started only with
the TGS key.
The message does not appear if the
TGS key reader is not installed or if the
use of the TGS key is disabled (see
the Configuration Menu section in the
software part) so that exercises can
be started only with the control panel
keys.
03056011
0SM00427AE-M1_UK.indd 31 02/07/2010 9.49.39