TP8-64 - User Manual General Features
1-3
1.4 PROGRAMS
The control panel controls up 8 programs which can be programmed both by the installer or the Master. The programs
group a certain number of zones that are enabled simultaneously for the detection of alarms on arming of the program.
The programs can be armed singularly, i.e. one program at a time (single arming) or several programs simultaneously
(multiarming) according to programming.
Common zones (relevant for multiarming only)
If one zone is included in more programs and has been enabled for the common zone function, it is enabled only if all
the programs it belongs to are armed. For instance, if one system is divided into two appartments which share the
same entrance, the owners of the appartments can arm/disarm the proper part of the system independently with two
standard user codes, but they cannot arm the common zone (entrance) on their own. The common zone is enabled
only if both programs it belongs to are armed contemporaneously.
1.5 COMPOSITION OF THE CONTROL PANEL
TP8-64
To Next Page
