Tecnoalarm TP8-64 - Programming of the Keys

Programming User Manual - TP8-64
3-10
z Automatic communicator block on disarming
Enables the code for the automatic interruption of the active alarm calls and those
in queue on disarming.
z Manual communicator block
Enables the code for the manual interruption of the active alarm calls and those in
queue entering the user code again and pressing EXIT after disarming.
z Remote disab. (disabling of remote arming/disarming by phone)
Disables the code for arming/disarming of the programs (programmed
appropriately) by phone.
z Direct disab. (disabling of direct arming/disarming)
Disables the code for direct arming, i.e. simultaneous arming of all the programs
associated by entering the code followed by the #(hash) key, but is obliged to
select them manually.
z Excl. disab. (disabling of zone exclusion)
Disables both the voluntary exclusion of zones and the automatic exclusion of
open zones. If the control panel is armed in the presence of open zones, these will
release an alarm at the end of the arming phase.
Commands available
+ yw to select the option
+ # to enable the option
+ * to disable the option
+ EXIT to confirm and quit
Viewing of the current settings
[ ] option disabled
[ # ] option enabled
3.8 PROGRAMMING OF THE KEYS
Select the keys menu and confirm by clicking on the # key.
The control panel controls up to 32 electronic keys that can be enabled forarming/
disarming and activation/deactivation of the first 6 programs (1...6) of the control panel.
Commands available
+ yw to select the key 1...32
+ # to confirm
Options available
z Access periods
z Programs
z Attributes
z Learning
3.8.1 ACCESS PERIODS
Select the access periods (1...8) during which the key is to be enabled. Outside these
periods of time, arming/disarming and the activation/deactivation of by-pass will be
denied.
Commands available
+ yw to select the access period 1...8
+ # to enable the key during the access period
+ * to disable the key during the access period
+ EXIT to confirm and quit
Viewing of the current settings
[ ] key not enabled during the access period
[ # ] key enabled during the access period
3.8.2 PROGRAMS
Select the programs (1...6) the code is to be enabled for.
Commands available
+ yw to select the program 1...6
+ # to associate the program to the key
+ * to undo the association
+ EXIT to confirm and quit
Viewing of the current settings
[ ] key not enabled for the program
[ # ] key enabled for the program
Menu 12
Keys
Keys 1
Key 01
Key 01 1
Access periods
Access periods
Period 01 [ # ]
Key 01 2
Programs
Programs
Program 01 [ # ]
Key 01 3
Attributs
Key 01 4
Learning