TP8-64 - User Manual Signaling
2-5
z Cut telephone line
Signaling on display
In case of GSM fault and cut telephone line alarm, in addition to LED signaling, on the
display is viewed a specific alarm message.
z LED blinking = general alarm active.
z LED on = a general alarm has been stored in the event buffer of the
control panel (alarm memory).
2.1.2 CONTROL LED - YELLOW
PROGRAM STATUS LED
The yellow program LED signal program status:
z LED blinking quickly = the pre-arming phase is active (10s after selecting the
programs to be armed).
The pre-arming phase permits arming/disarming of other
programs. Then, the volontary exclusion of zones from
the detection of alarms is possible.
z LED blinking slowly = the program is partset.
The zones included in the by-pass program are
temporarily disabled from the detection of alarms.
z LED on = the program is armed
z LED off = the program is in stand-by
Arming and disarming as well as the activation and deactivation of by-pass are logged in
the event buffer of the control panel.
LINE LED 0
The LINE LED signals the status of the console connection:
z LED on = the console is connected and works correctly
z LED off = the serial line is disturbed or badly connected.
CONSOLE STATUS LED CM
The console status LED CM signals the status of the console:
z LED on = keystroke
z LED off = the serial line is disturbed or badly connected.
! TROUBLE !
CUT TEL. LINE
! TROUBLE !
Mobile
To Next Page
