TP8-64 - User Manual Control by keypoint
5-7
5.2.2.2 MULTIPLE ARMING
DIRECT DISARMING ENABLED
Introduce an electronic key enabled for the program armed into the key reader.
All the programs associated are disabled simultaneously and the corresponding led are
switched off.
Remove the key from the key reader.
DIRECT DISARMING DISABLED
Introduce a key enabled for the programs armed into the key reader and remove it until
the program to be disarmed is selected.
The program selected is disarmed and the corresponding LED is switched off.
Remove the key from the key reader.
5.2.3 BY-PASS
When the control panel is armed, it is possible to deactivate temporaneously part of the
system. Upon activation of the by-pass, the zones enabled for by-pass and included in
the program/s armed and partset are deactivated. The other zones are not affected.
The exclusion of zones persists until deactivation of the by-pass or disarming of the
programs they are included in.
Introduce an electronic key enabled for by-pass into the key reader.
The led corresponding to the programs partset start blinking.
Remove the key from the key reader.
5.2.3.1 ACTIVATION OF BY-PASS DURING THE ACCESS PERIODS
It is possible to define up to 8 access periods of the electronic keys. As a consequence,
the electronic keys are enabled for by-pass during the access periods associated by the
installer or the holder of the master code only.
5.2.3.2 DEACTIVATION OF BY-PASS
Introduce an electronic key enabled for by-pass into the key reader.
The LED corresponding to the programs partset start blinking quickly signaling that the
arming phase is active. After the arming phase, the LED become lit.
Remove the key from the key reader.
WARNING
The electronic key introduced will effect disarming exclusively of those programs it is enabled for. Other
programs armed are not affected.
WARNING
The zones excluded are those associated to the by-pass function and included in the programs
associated to the key. All the programs associated to the electronic key introduced are partset
simultaneously. If one of the programs associated is already partset, the introduction of the key causes
the reactivation of this program in its integrity.
WARNING
Outside the access periods associated the electronic keys are not accepted by the control panel and
any attempt at acceding to the system will have no effect.
When trying to do so, access denied is signaled.
To Next Page
Loading...
