Tecnoalarm TP8-64 - GSM Module Test

TP8-64 - User Manual Programming
3-15
3.12.7 GSM MODULE TEST
On initiation, on the display is viewed in sequence:
z The status of the GSM telephone communicator
z The GSM signal power:
* insufficient
** bad
*** reasonable
**** good
***** optimum
z The firmware version of the GSM telephone communicator
Commands available
+ EXIT to quit the submenu
3.13 ENABLING OF REMOTE ACCESS
Select the menu Option.
+ # to confirm
Enables the installer to accede to the control panel via telephone line using the
TECNOALARM programming and monitoring software.
Commands available
+ # to disable remote access
+ * to enable remote access
+ EXIT to confirm and quit
Viewing of the current settings
[ ] remote access disabled
[ # ] remote access enabled
Test 9
GSM
GSM
Device OK
GSM
Signal *****
GSM
Ver. 1.5
Menu 19
Options
Options
Rem. access [ # ]