Tecnoalarm TP8-64 - Remote Activation;Deactivation of Devices

Control by telephone User Manual - TP8-64
6-2
6.1.3 REMOTE ACTIVATION/DEACTIVATION OF DEVICES
Enter the remote control menu by pressing:
+ 3
The following message is played:
Options available
z Verificaton of the status of the remote devices
z Remote activation/deactivation of the devices
Verification of the status of the remote devices
To check the status of the remote devices, enter the number of the device:
+ 1...8
The control panel plays the message corresponding to the status of the device (active or in stand-by).
Remote activation/deactivation
To activate or deactivate the devices, press * followed by the number of the device:
+ *1 device 1
...
+ *8 device 8
The control panel plays the message corresponding to the status of the device (active or in stand-by).
6.1.4 REMOTE DIGITAL VERIFICATION RDV
Enter the RDV menu by pressing:
+ 4
The following message is played:
The RDV menu permits the remote verification of the RDV detectors connected. RDV detectors are doppler detectors
able to transmit a microwaves that correspond exactly to the movement detected. The waves are interpreted and
converted into sound waves by the control panel and transmitted via telephone.
To verify one of the RDV detectors, enter the zone number:
+ 1...64
The control panel transmits the sound wave corresponding to the doppler signal detected on the zone selected for
approximately 30 seconds.
If the zone selected is not controlled by an RDV detector, the control panel plays a vocal error message (RDV denied).
6.1.5 OPENING MESSAGE
Enter the message menu by pressing:
+ 5
The following message is played:
Options available
z Recording of the opening message
z Playing of the opening message
Recording of the opening message
The duration of the opening message is fixed. Thus, it is recommended to record messages with a duration similar to 10
seconds.
To record the opening message, press:
+ 1
The control panel emits 2 beeps and initiates recording immediately after the 2 beeps.
Menu remote control. To return to menu press hash.
Menu RDV. To return to menu press hash.
Opening message. To return to menu press hash.
WARNING
Recording of the opening message requires the master code.