Tecnoalarm TP8-64 - Page 16

Signaling User Manual - TP8-64
2-2
CONSOLE LCD300/S
The LCD300/S console is composed of:
z Rubber keypad with 16 keys
z 22 LED
z Backlit liquid crystal display (LCD) with two lines of 16 caracters each
z Blank labels for the program names
z Speaker for vocal messages
z Plastic lid
The console must be connected via RS485 serial bus to the control panel and its address must be configurated by
SW1dipswitch.
1
LED off
LED blinking
LED on
No alarm
Alarm active
Alarm memory
3
LED off
LED blinking quickly
LED blinking slowly
LED on
Program in stand-by
Program in arming phase
Program partset
Program armed
LED off
LED blinking
LED on
No alarm
Alarm active
Alarm memory
LED off
LED on
Console in stand-by (no key pressed)
Console in use (key pressed)
7
LED off
LED blinking
LED on
No alarm
Alarm active
Alarm memory
9
LED off
LED blinking
LED on
No alarm
Insufficient battery voltage
Alarm memory
LED off
LED blinking
LED on
No alarm
Mains power (230V AC) missing
Alarm memory
LED off
LED on
Mains power (230V AC) missing
Mains power (230V AC) ok
13
14
SCREWS
SCREW PROTECTION LID
6
DISPLAY
Shows date/time or active parameter
BATTERY LED
MAINS (POW ER FAILURE) LED
MAINS LED
11
12
KEYPAD
PROGRAM ALARM LED
RECLOSABLE PROTECTION LID
PROGRAM STATUS LED
GENERAL ALARM LED
COMMAND MODE LED
PUSH-BUTTON OF THE PROTECTION LID
TAMPER ALARM LED
2
4
5
10
8