Control by keypoint User Manual - TP8-64
5-10
5.4.1.1 ARMING WITH CODE
Enter a valid code (master or standard user code enabled for the programs to be armed),
e.g. master code (default code 12345):
+ 12345
The green LED 5 is lit.
For the 8 seconds to come it is possible to select the programs to be armed/disarmed
(pressing the program number the first time the program is selected, pressing it the
second time it is deselected). On every keystroke the counter is reset.
Select the programs to be armed, e.g.:
+ 13
The red LED corresponding to the programs selected start blinking.
+ # to confirm the selection and stop the counter without waiting for 8 seconds.
ZONE EXCLUSION TIME
For 8 seconds after selecting the programs, it is possible to exclude manually some of
the zones from the detection of alarms with a procedure explained lateron.
If you do not wish to exclude any zone, it is possible to confirm the selection without
waiting for expiry of the zone exclusion time by pressing # (hash) again:
+ # to confirm the selection and abort the zone exclusion time
EXIT TIME
The zones defined as delayed upon arming observe the exit time programmed by the
installer.
If the programs selected contain delayed zones, on expiry of the zone exclusion time
follows the exit time and the programs in question are only armed on expiry of the exit
time.
Once the exit time has expired, the program LED become lit and remain lit until
disarming of these programs.
If the programs selected do not contain delayed zones, on expiry (or abort) of the zone
exclusion time, the programs in question are armed and the corresponding red LED
become lit immediately.
5.4.1.2 EXCLUSION OF OPEN ZONES
After selecting the programs to be armed, during the 8-seconds zone exclusion time, if
there are open zones, the yellow LED 7 OCG is blinking.
A zone can result open for instance in case of fault of the detector connected.
To arm the programs selected excluding the open zones press:
+ *
5.4.1.3 QUICK ARMING
- Not permitted -
5.4.1.4 ARMING DURING THE ACCESS PERIODS
It is possible to define up to 8 access periods of the codes. As a consequence, the
codes are enabled for arming and disarming during the access periods associated by
the installer or the holder of the master code only.
WARNING
The electronic keypad permits the control of the first 4 programs, evenif the codes are able to control all
8 programs. Codes enabled for the programs 4 to 8 are not recognize by these key readers. The status
of the other programs is not viewed by the LED on the electronic keypad.
WARNING
Whereas the master code is always enabled for all the programs, the user codes control merely those
programs they have been enabled for by the installer or the holder of the master code.
WARNING
If the open zones are not excluded, on expiry of the zone exclusion time (and perhaps the exit time) the
programs are armed and the open zones are activated. As a consequence, the alarm is released.
To Next Page
Loading...
