Checking Performance-222 DSO Operators
Table
A-1
(cont)
r-Connector
Small, Flat-tip
screwdriver.
Description
play alignment.
Adjust intensity
and focus
controls.
Minimum
Specification
Connectors:
BNC.
Tektronix Part
Number
103-0030-00.
Signal inter-
connection.
Use
A.3 PERFORMANCE CONDITIONS
Example
of
Test Equipment
Jumper Wire
The performance limits in this performance check are valid under the
following conditions:
An
instrument self calibration must have been done within
+5OC
of the
present ambient operating temperature.
C~nfle~t~r~:
Banana; length
3-inches or more.
The instrument must be checked at an ambient temperature between
-10°C
and
+55OC.
External trigger
self calibration.
A.4 PERFORMANCE CHECK INTERVAL
It is recommended that a complete performance check be done on
the instrument at least once each year.
A
more frequent interval is
advised if the instrument is used under severe conditions. If the
checks indicate a need for readjustment or repair, refer the instrument
to the nearest Tektronix repair center.
REV
MAR
1989
To Next Page
Loading...
