Maintenance
4. Separate the two halves of the
compensation box enclosu re.
5. Remove the meta l shield from the main
assembly.
6. If you are only replacing the switch panel,
disconnect the panel, replace it, and
reassemble the compensation box.
7. If you are replacing the cable or
compensation box, disconnect the cable
connector.
8. Install the new cable or compensation box
by perf orming this procedure in r everse. I f
you are replacing the cable, refer also to the
Cable/Circuit Board Assemb ly procedure
to comp lete the cable replacement.
TCP0030 C urren t Probe Instruction Manual 75
To Next Page
Loading...
Need help?
General
