66
PPTP VPN: Enable/Disable PPTP function.
PPTP Server
Auth. Type: Setup the authentication type for client - Chap/Pap, Pap, Chap or MS-CHAPv2 Encryption. When
using PAP, the password is sent unencrypted, whilst CHAP encrypts the password before sending, and also
allows for challenges at different periods to ensure that an intruder has not replaced the client. When passed
the authentication with MS-CHAPv2, the MPPE encryption is supported.
Encryption Mode: Available when using MS-CHAPv2 authentication mode. The data can be encrypted by
MPPE/MPPC algorithm
Assigned to Peer IP Address start from: Enter the IP address that will be assigned to remote PPTP client. The
IP address cannot in DHCP IP Pool range.
Local IP Address: Enter the IP address for PPTP tunnel virtual interface.
Server Account
Name: Enter the name for this account profile.
Tunnel: Enable/Disable this tunnel.
Username: Enter the username for login authentication.
Password: Enter the password for login authentication.
Peer IP: Enter the peer side LAN IP address for LAN to LAN type.
Peer Subnet Mask: Enter the peer side LAN subnet mask for LAN to LAN type.
PPTP Client
Name: Enter the name for this client rule.
Server Address: Specify the remote PPTP server IP address or domain name.
Username: Enter the username for PPTP login authentication.
Password: Enter the password for PPTP login authentication.
Auth.Type: Setup the authentication type for connecting to PPTP server. This setting must follow server side.
Encryption Mode: Setup MPPE encryption for PPTP tunnel, MPPE can only be enabled when Auth. Type set
to MS-CHAPV2. This setting must follow server side.
Default Gateway: Make this PPTP tunnel as default gateway for all local traffic when it is checked.
Peer IP: Enter the peer side LAN IP address for LAN to LAN type.
Peer Subnet Mask: Enter the peer side LAN subnet mask for LAN to LAN type.
To Next Page
Loading...
