77
Secret Key: Enter the secret key for tunnel authentication.
Assigned to Peer IP Address start from: Enter the IP address that will be assigned to remote L2TP client. The
IP address cannot in DHCP IP Pool range.
Local IP Address: Enter the IP address for L2TP tunnel virtual interface.
Server Account
Name: Enter the name for this account profile.
Account: Enable/Disable this account.
Username: Enter the username for login authentication.
Password: Enter the password for login authentication.
Peer IP: Enter the peer side LAN IP address for LAN to LAN type.
Peer Subnet Mask: Enter the peer side LAN subnet mask for LAN to LAN type.
L2TP Client
Name: Enter the name for this client rule.
Server Address: Specify the remote L2TP server IP address or domain name.
Username: Enter the username for L2TP login authentication.
Password: Enter the password for L2TP login authentication.
Tunnel Authentication: Enable/Disable the tunnel authentication.
Secret Key: Enter the secret key for tunnel authentication.
Authentication Type: Setup the authentication type for connecting to L2TP server. This setting must follow
server side.
Encryption Mode: Setup MPPE encryption for L2TP tunnel, MPPE can only be enabled when Auth. Type set to
MS-CHAPV2. This setting must follow server side.
Default Gateway: Make this PPTP tunnel as default gateway for all local traffic when it is checked.
Peer IP: Enter the peer side LAN IP address for LAN to LAN type.
Peer Subnet Mask: Enter the peer side LAN subnet mask for LAN to LAN type.
To Next Page
Loading...
