79
Click Add New Connection to create IPSec connections.
IPSec Connection Setting
Connection Name: A given name for the connection (e.g. connection to office).
Active: Select Yes to activate the tunnel.
WAN Interface: Select the existing WAN interface for the IPSec connection, when you select 3G/4G-LTE
interface, the IPSec tunnel would via this interface to connect to the remote peer.
Remote Gateway IP: The WAN IP address of the remote VPN gateway that is to be connected, establishing a
VPN tunnel.
Protocol: Set the protocol and the local/remote port.
Local Network: Set the IP address or subnet of the local network.
4 Single IP Address: The IP address of the local host, for establishing an IPSec connection between a
security gateway and a host (network-to-host).
To Next Page
Loading...
