LE910Cx Hardware Design Guide
1VV0301298 Rev.40 Page 146 of 149 2023-03-16
Not Subject to NDA
Revision Date Changes
Section 10.2 – Picture added for Cx-SV/LA variants
Section 14.2 – Japan Radio Law comment added
9 2019-03-06 Table 1 and 4 Variants updated
Section 2.7 - RF Parameters updated
Section 3.2 – Note added for C1 bis variants
Section 6.2 – Power consumption update
Section 7 – Note added for C1 bis variants
8 2018-12-12 14.1 FCC/ISED Regulatory Notices updated for LE910C1-SA
and LE910C1-ST
7 2018-11-19 14.1 FCC/ISED Regulatory Notices updated for LE910C1-SV
6 2018-10-25 Table 1 & 4 – Added -SA, ST, SV and LA variants.
Table 5 – Added B14
Section 2.5.1 – Updated Temperature Range
5 2018-09-16 Section 14 – Adding Antenna gain and FCC ID & IC numbers for LE910C1/C4 NF.
Section 5.2 – Fixed typo related to power up timing.
4 2018-08-20 Table 1 & 4 - Added LE910C4-EU variant
Section 2.3 – Updated SIM interface max speed
Declared HSIC interface as optional throughout the document
Section 2.6.2 – Updated RF frequency table
Section 6.2 – Added clarification related to DRX and CFUN=5
Section 8.1 - Corrected Typo related to USB_VBUS pad number
Section 8.4.1- Clarified note about DTR pin
3 2018-07-18 Section 2.8.1 - Fixed typo related to module size
General - Align cross reference links across the document
2 2018-06-14 Template update and pagination update
Section 1.5 – Updated AT Command UG reference
Section 2.6.1 - Updated Band support table
Section 6.3.2 - Updated Thermal design guidelines
Section 8.3 - Removed “optional” term from Ethernet interface
1.13 2018-05-17 Added new variant LE910C1-NF
Section 2.6.1 - Added band 66 support for LE910Cx-NF
Section 2.6.2 - Added band 66 and band 71 to frequency table
Section 3.1 - Updated value of SIM internal pullup
Section 8.3 – added clarification regarding Ethernet control interface logic levels
To Next Page
Loading...
Need help?
General
