Compact Track Loader
12. Undercarriage Disassembly and Assembly
12-5
Figure 12-14
5. Locate the wheel marked “A” in fig. 12-14.
Figure 12-15
6. Perform steps 1-7 of the wheel removal
procedure in this chapter to remove the outer
front idler wheel.
Track
Drive
Lu
s
Figure 12-16
7. With the wheel removed and the drive sprocket
table lowered, the track is ready for removal.
8. Pull the track outward as shown.
Track Installation
To remove the tracks, the machine must be jacked
up and placed on jack stands sturdy enough to support the
weight of the machine. Terex approved jack stands are
recommended.
Track
Drive
Lu
s
Figure 12-17
1. Place the track around the rear wheels and on
top of the drive sprocket. Make sure the track
drive lugs mesh with the sprocket.
Apply
Soa
Figure 12-18
2. Using soap, lubricate the front inside wheel. Pull
the track around the outside wheel shaft and
onto the front inside wheel. The soap will help
the track slide onto the wheel.
To Next Page
