Tescom ACT6000 - Automatic pre-configured Telephone DELTest sequence; Pre-configured masks for manual SELT or SELT; DELT line tests; DBPO Masks; Supplied Accessories (base kit)

ACT6000 User Guide – January 2021 Page 13 of 52
Rate evaluation (Up & Down stream) and SNR for ADSL - ADSL2+ - VDSL2 - VDSL
Plus** masks.
Automatic pre-configured Telephone DELTest sequence * (with two ACT6000 in
Master/Slave mode) for POTS link qualification *** by Signaling and Transmissive tests
according to the M.1040 voice mask.
Pre-configured masks for manual SELT or SELT / DELT line tests sequences *
· Wide band: VOICE, MODEM 56k, ISDN, HDSL 1p and 2p, E1, T1, SHDSL, ADSL,
ADSL2+, and VDSL2-12a, VDSL2-17a, VDSL2-30a, VDSL Plus **.
For VOICE and MODEM 56K is allowed the special DELT modality “EIA-464 4W E&M”
to perform the Insertion-Loss and Noise level on special PCM systems with separate TX
and RX unidirectional channels.
DBPO Masks - Automatic generation of the Threshold Mask for VDSL related to the
primary line parameters included the “ESEL” measured by ADSL2+ SELT Sequence *
Notes:
* by Advanced Software ASW-1/II;
** by adoption of EBM 30 (ACT-13) optional module;
*** by adopting the ACT-11 “POTS –SUB” Module installed on the ACT-12 “DMM Module”.
Supplied Accessories (base kit):
ACT6000 Base Instrument, included:
- Nylon Carrying Case with pocket for accessories;
- User Guide (English or Italian language, as requested);
- AC Power Supply and Battery Charger (Line Input: 100-220 Vac; Output: 20 Vdc);
- Banana-Banana + Crocodiles cables (2.30m total length);
- Ground Cable unipolar Banana-Crocodile cable;
Extra cost Accessories and Optional HW/SW Modules
- ASW-1/II - Advanced Software 1 (see the above description).
- ACT-11 POTS Module (Subscriber Simulator for POTS for signaling tests);
- ACT-12 DMM Module (Digital Multimeter for metallic tests);
- ACT-13 EBM30 Module (Extension Band for 35 MHz operation);
- ACT-14 USB Pen-Drive 8 GB;
- ACT-15 Probes to perform Medium & High Band PSD measurement on fed lines;
- ACT-16 Plug/Probes to perform Medium & High Band PSD measurements on fed lines.
- ACT-17-B 50 dB Balanced Attenuator, High Z input / 150 Ohm output;
- ACT-17-U 50 dB Unbalanced Attenuator High Z input / 75 Ohm output, included coaxial
cable tests BNC/BNC 75 Ohm;
- ACT-18 Real Time Resistance Meter module;
- ALT-05 Headset with 2m cable and RJ-45/4 connector;
- ALT-09 Resistive Termination Set (100, 120, 135, 150 and 600 W);
- ALT-16 Triple Banana to BNC Adapter, included coaxial cable tests BNC/BNC 75 Ohm.