9 Performing the measurement
56
Set parameters or enter values.
All values that can be modified have a dotted underlining.
Three circle diameters and three pipe lengths can be entered, which
are then used to calculate three partial volumes. The pipe volume is
calculated by adding these three partial volumes.
Start stabilization time: tap . If applicable, follow instructions.
Reading is displayed.
Stabilization time is finished.
End stabilization time early: tap .
End measurement: tap .
Measuring time starts.
The readings are automatically saved and displayed after the
measurement has been completed.
The measuring value result can be assessed.
Conclude measurement: tap Next.
If applicable, repeat measurement: tap .
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
