TESTO Saveris T3 Commissioning Instructions

6 Commissioning
23
6.5 Commissioning of radio data loggers
in testo Saveris
6.5.1 Inserting batteries into Saveris radio data
logger
1
Undo screws on the rear of the Saveris radio data logger.
2
Remove housing cover of the Saveris radio data logger .
3
Insert batteries .
Ensure that you insert the batteries correctly.
The correct polarity is illustrated in the respective battery compartment.
4
Place housing cover on the housing of the Saveris radio data logger.
5
Screw cover tightly onto the housing.
A control switch is located in the housing which is actuated through the
cover. To this end, the cover must be screwed to the housing of the
Saveris radio data logger without any gap.
If the cover is not screwed on without any gap, the Saveris radio data
logger cannot be operated.

TESTO Saveris T3 Specifications

General

Brand	TESTO
Model	Saveris T3
Category	Measuring Instruments
Language	English