TESTO Saveris T3 Commissioning Instructions

6 Commissioning
72
6.10.3.4 Removing components from the wall bracket
1
Using a narrow slotted screwdriver,
unlock the data logger on the
wall bracket .
2
Remove data logger from the wall bracket by moving upwards as
shown.
6.10.4 Checking the measurement system again
1
Perform another test run on the measurement system; see section 6.11
Performing test run.
After mounting the hardware, check the system again to test the
measurement system is working perfectly.
This enables you to detect whether Saveris radioi data loggers are
located outside of the range of the Saveris base, if applicable, or if
there is interference to the radio link due to structural conditions.

TESTO Saveris T3 Specifications

General

Brand	TESTO
Model	Saveris T3
Category	Measuring Instruments
Language	English