TESTO Saveris T3 Commissioning Instructions

6 Commissioning
27

If the status LED flashes green, the gateway is in configuration mode.
4
Check the network settings of your PC. The gateway must be detected
as an RNDIS device (driver is loaded automatically).
6.6.3 Configuring the BT Gateway for testo 182
1
Open the configuration interface for the gateway via the browser.
2
Enter the default configuration IP address of the gateway
(172.31.250.1) in the address line.

The following window is displayed:
3
Select the Gateway type (registration or readout gateway) (Select
your testo Saveris Gateway BT configuration) and enter your
Location.
4
Save information: [Save]

The following window is displayed:

TESTO Saveris T3 Specifications

General

Brand	TESTO
Model	Saveris T3
Category	Measuring Instruments
Language	English