TESTO Saveris T3 Commissioning Instructions

6 Commissioning
29
6.6.3.2 Configuring operation via Ethernet / LAN
1
Select whether the gateway is to be operated via DHCP or manual IP
configuration.

DHCP selection: no further settings necessary.

Manual IP selection: Enter the following data for a static IP
configuration:
• the required IP address
• the subnet mask
• the default gateway
• DNS server (optional)
2
Confirm your settings for the Network tab with [Save].
Optional: carry out NTP (time server) configuration.
The NTP servers transmit the date and time to the gateway. If
necessary, the NTP servers already entered by Testo can be
adjusted.
Make a note of the gateway’s newly assigned IP address.
3
Confirm changes to the NTP configuration by clicking on [Save].
6.6.3.3 Configuring the AWS Bucket
1
Click on the AWS Bucket tab at the top to configure your bucket.
A gateway configured as a registration gateway can only be
assigned to one bucket. A gateway configured as a readout
gateway can be connected to multiple buckets.
2
Confirm your settings for the AWS Bucket by clicking on [Save]. The
access data are checked and if the connection was successful,
confirmation is displayed.
3
Restart to confirm the settings
Network and AWS Bucket settings can later be changed at
any time. Changing the gateway type and the location is only
possible via a factory reset. To do this, press the Reset key for
longer than 30 seconds.

TESTO Saveris T3 Specifications

General

Brand	TESTO
Model	Saveris T3
Category	Measuring Instruments
Language	English