TESTO Saveris T3 Commissioning Instructions

6 Commissioning
56
3
Hold the connect key on the rear of
the Saveris router pressed down until
the LED on the Saveris router
starts to flash orange.

The LED on the Saveris router briefly turns green when this has
been detected by the Saveris base.
The LED on the Saveris base briefly flashes green and a prompt to
register more data loggers or Saveris routers appears in the display of
the base.
It is not possible to register multiple routers on the Saveris base at the
same time. Multiple Saveris routers can only be registered one after the
other.
4
Press the [Esc] key on the Saveris base if there are no other
components to be registered.
Information about the necessary execution of the startup wizard is
shown on the display for about ten seconds. The Saveris base then
switches to the Info System menu where the number of registered
components is now displayed.
5
Press the [Enter] key if there is another component to be registered;
see previous step.
6.9.5.4 Assigning data loggers
To assign a data logger to a Saveris router, both must be registered on
the Saveris base.
1
Under Start | All programs | Testo, click on Testo Saveris startup
wizard.

TESTO Saveris T3 Specifications

General

Brand	TESTO
Model	Saveris T3
Category	Measuring Instruments
Language	English