TESTO Saveris T3 - Page 42

6 Commissioning
42
3
Enter the IP address of the Saveris
base. This is located on the Saveris
base in the Info Base window.
4
Click on [Continue].
5
Click on [Units] to change the
temperature unit for the system.
6
Click on [MKT] (Mean Kinetic
Temperature) to simulate the effect of
temperature fluctuations over a
specific period of time.
1. Mark the channel.
2. Click [Add] to start the MKT
calculation for the selected
channel.
Several timestamps can be set for each channel.
7
Click on [OK].
8
Make any further changes to the existing system settings as required.