TESTO Saveris T3 - Page 51

6 Commissioning
51
17
Click on [Next >].

If a Saveris router is registered on the
Saveris base, the configuration of the
connection type for the probes is
shown.
If you have not registered a router,
continue as from step 25.
18
Click in the Connection type cell of the data logger which needs to be
assigned to a Saveris router.

The cell is shown as a selection list.
19
Use the button to open the selection list and select the Saveris router
which the data logger needs to be assigned to.
Data loggers which are in a mobile zone cannot be assigned to a
Saveris router.
20
Perform steps 18 and 19 for all other data loggers with measurement
data that need to be transmitted to the Saveris base via a Saveris
router.
21
Click on [Next >].

The wizard is displayed with the
setting for the start of measurement
and with the list of newly registered
data loggers.
22
Postpone start of measurement if necessary.