TESTO Saveris T3 Commissioning Instructions

7 Maintenance
84
12
Click on [Next >].

If a Saveris router is registered on the
Saveris base, the configuration of the
connection type for the Saveris radio
data loggers is shown.
If you have not registered a Saveris
router, continue as from step 17.
13
Click in the Connection type cell of the Saveris radio data logger which
needs to be assigned to a Saveris router.

The cell is shown as a selection list.
14
Use the button to open the selection list and select the Saveris router
which the Saveris radio data logger needs to be assigned to.
15
Perform steps 13 and 14 for all other Saveris radio data loggers with
measurement data that need to be transmitted to the Saveris base via a
Saveris router.
16
Click on [Next >].

The wizard is displayed with the
setting for the start of measurement.
17
Postpone start of measurement if necessary.
18
Click on [Finish] to complete the commissioning of the hardware.

A message about the successful configuration of the hardware is
displayed.
19
Confirm the message by clicking [OK].

The new hardware is now ready for operation.

TESTO Saveris T3 Specifications

General

Brand	TESTO
Model	Saveris T3
Category	Measuring Instruments
Language	English