Hardware Installation
7. Note that WinXP shows a warning that the driver is not certified by Microsoft®. Ignore this warning and
click "Continue Anyway" (see Figure E-4 ).
Figure E-4. WinXP Driver Installation
8. The Wizard installs the driver files.
9. The Wizard shows a message that it has finished the installation of the software for "MSP-FET430UIF
(TI USB FET) Adapter".
10. After closing the Hardware Wizard, Windows automatically recognizes another new hardware device
called "MSP-FET430UIF - Serial Port".
11. Depending on the current update version of the operating system, corresponding drivers are installed
automatically or the Hardware Wizard opens again. If the Wizard starts again, repeat the steps
described above.
76 MSP-FET430UIF Installation Guide SLAU138F – June 2004 – Revised March 2007
Submit Documentation Feedback
To Next Page
Loading...
Need help?
General
