268
Chapter 13: Link and the CBL
à
CBR Application
APPS.DOC Chapter 13: Link and CBL/CBR Application, English Julie Hewlett Revised: 02/07/01 10:34 AM
Printed: 02/07/01 10:35 AM Page 268 of 22
MIN and MAX
MIN
and
MAX
refer to the minimum and maximum
UNIT
values
for the specified
PROBE
. Defaults are listed in the table on page
267. See the CBL 2/CBL and CBR guidebook for specific
MIN
à
MAX
ranges. Enter values using the number keys.
UNITS
The results are displayed according to the
UNITS
specified. To
specify a unit measurement (
Temp
or
Sonic
probes only),
highlight the one you want using the cursor keys, and then
press
b
.
DIRECTNS (Directions)
If
DIRECTNS=On
, the calculator displays step-by-step directions
on the screen, which help you set up and run the data
collection. To select
On
or
Off
, highlight the one you want with
the cursor keys, and then press
b
.
With the
Sonic
data collection probe, if
DIRECTNS=On
, the
calculator displays a menu screen before starting the
application asking you to select
1:CBL
or
2:CBR.
This ensures
that you get the appropriate directions. Press
1
to specify
CBL
or
2
to specify
CBR
.
Data Collection Comments and Results
To label a specific data point, press
b
to pause the data
collection. You see a
Comment=
prompt. Enter up to a
six-character comment using the Text editor (
-
t
) or
number keys. The calculator automatically converts the
comment labels and the corresponding results into list
elements using the following list names (you cannot rename
these lists):
To Next Page
Loading...
