Programming 610
Editor to create a new program, and paste them into the blank program. Then modify the
commands as necessary.
Note: This inserts all the commands on a single line. You do not need to split them into
separate lines.
You can create and use only one custom menu at a time. If you need more, write a
separate program for each custom menu. Then run the program for the menu you need.
Restoring the Default Custom Menu
To restore the default:
1. From the Home screen’s normal menu (not the custom menu), select
Clean Up:
2 ˆ
3. Press ¸ to execute the commands and restore the default.
When you restore the default, any previous custom menu is erased. If the previous
menu was created with a program, you can run the program again if you want to reuse
the menu later.
2. Select
3:Restore custom default.
This pastes the commands used to create the
default menu into the entry line.
To Next Page
Loading...
Need help?
General
