Premier 24 Installation Manual Installation
INS248 15
Remote Keypads
The Premier LCD, LCDL, LCDP and LCDLP keypads all have:
• 2 fully programmable zones
• 1 fully programmable –ve applied output
• A fully programmable LED indicator (‘Info.’ LED)
In addition the LCDL and LCDLP keypads have:
• A fully adjustable speaker output
The LCDP and LCDLP keypads also have:
• A built in Proximity Tag/Card reader
Keypad Layout
Zone 2
T A
Zone 1
T
A
NETWORK
+
TR
-
O/P
Address
Switch
Output
Network
Terminals
Tamper
Switch
Speaker
Output
Zones
Piezo
Sounder
2431
On
SPK
Connecting Keypads
Keypads are connected to the network terminals located at
the bottom left hand corner of the control panel (see pages
13 & 14 for connection details).
Keypad Addressing
Each keypad must be assigned a different address using
the DIL switches located on the left hand side of the PCB.
The table below shows the keypad addressing:
Address DIL 1 DIL 2 DIL 3 DIL 4
1 On or off Off Off Off
2 431
2 Off On Off Off
2 431
3 Off Off On Off
2 431
4 Off Off Off On
2 431
Engineers On On On On
2 431
!
Never set two keypads on the same network to the
same address.
When using a keypad as an Engineer’s keypad, the
DIL switches must all be ‘On’.
Zone Numbering
The table below shows the zone allocation when the
keypads are installed:
Address
Zones
(Network 1)
Zones
(Network 2)
1 Unmapped Unmapped
2 Unmapped Unmapped
3 Unmapped Unmapped
4 Unmapped Unmapped
!
The zones inside the keypads are not seen by the
system until they have been mapped to a zone
number (see page 51 for details).
Keypad Zones
The keypad has two programmable zones (see page 21 for
wiring details). Each zone is also fully programmable (see
page 34 for programming details).
Keypad Output
The remote keypad has one programmable output, which
can be used to drive auxiliary devices such as LED’s,
sounders or relays etc. Wire as per Panel Outputs shown on
page 24 (see page 53 for programming details). The
electrical characteristics for the output are shown below:
Output Max Current Type
1 100mA Switched -ve
Keypad Speaker Output (LCDL/LCDLP Only)
The Premier LCDL and Premier LCDLP keypads have an
output that can be used for driving up to one 16Ω or two 8Ω
loudspeakers (see page 22 for wiring details).
!
The speaker volume is also fully adjustable (see page
51 for details).
Programmable ‘Info.’ LED
The ‘Info.’ LED on the front of the keypad can be
programmed to mimic the keypad output or show the
armed status of alarm (see page 51 for details).
Adjustable Backlighting
To adjust the keypad backlighting press the YES key for 5
seconds, then with the YES key still pressed use
&
to
increase or decrease the backlighting until the required
brightness is achieved, then release both keys.
!
The backlight can only be adjusted when the keypad
is not in a menu.
Keypad Lid Tamper
The lid tamper of each keypad can be disabled if required
using the relevant keypad option in the Keypad Setup menu
(see page 51 for details).
To Next Page
Loading...
