System Overview Premier 24 Installation Manual
4 INS248
1. History
This section shows the key milestones in the product development history, helping to identify when particular features were
implemented.
!
To confirm the Panel Type and software version, press ! followed by " on the keypad. The panel type and
software version will be displayed.
Version 1.8
• Support for iD.
iD wiring supported via Premier 24iXD Expander.
• Ability to print the log.
System log can be printed to serial printer
connected to Com port 1.
Version 2.0
• Software changed for new issue 8 PCB.
Version 2.02
• GSM UDL enabled.
Wintex up and downloading supported on
ComGSM.
Version 2.04
• Triple EOL (anti mask) support.
Version 7 – Issue 2 Manual
• EN50131 and DD6662 functionality.
Features required for EN50131 & DD6662 added
– eg keypad blanking.
• Support for iProx proximity tag readers.
• Support for 4XP 4 zone expander.
• Support for Radio Plus.
Intelegent Receiver supported on Com port 2.
(This is the internal receiver).
• Support for Premier OP8.
On board 8 channel output expander.
Version 7.1
• Disarm with Radio FOB only after entry.
Option to prevent unsetting by radio FOB until
entry timer started.
• Anti mask works on keypads and expanders.
Version 7.5 – Issue 2 Manual with Addendum ADD030-3
• PSU Monitor support.
PSU monitor option on 8XP Expander auxiliary
input.
Premier PSU Monitor.
Premier PSU200XP monitored power supply.
• AC off logged.
Mains failure recorded in system log.
Version 7.8
• Support for RadioPlus Network Receiver.
Version 8 – Issue 3 Manual
• 500 event Mandatory Log added.
• Option for silent radio FOB PA.
• Radio shock sensor supported.
Support for Intelligent Radio Shock Sensor added
in preparation for future introduction.
• Additional EOL and TEOL circuits supported.
Alternative End-of-Line and Triple-End-of-Line
resistor values supported for compatibility with
other manufacturers products.
• Access users logged.
Door strike events recorded in the system log.
To Next Page
Loading...
Need help?
General
