Texecom Premier 24 - Change Eng. Code; View ID Status; Print Log

Programming the Control Panel Premier 24 Installation Manual
82 INS248
Change Eng. Code
H73!:0! 3$-$6:TU
78958$$ )!V:5-<
Yes
78958$$ )!V:5-<
,L(89$! 7891!,0E$
Yes
V<$)!%% !,0E$!
!!!!!UU UUUU
Yes
????
Enter User code number
4, 5 or 6 digits long
V<$)!%% !,0E$
!!!!!UU +c_b
78958$$ )!V:5-<
R5$F!74 $8:!G09
This option allows the Engineer code (User 00) to be
changed. This code can be 4, 5 or 6 digits in length. The
system will allow a mixture of different length User codes.
View iD Status
Menu
Engineer Utils
View iD Status
YES to Select:-
Engineer Utils
Yes
Engineer Utils
View Event Log
Yes
................
...............N
................
...............M
Use AREA key to switch
from Normal loop scan to
Midrail scan and the NO
key to switch back
Area
................
...............N
Zones 1-16
Zones 17-24
Scan Mode
N=Normal
M=Midrail
Zone Status
1=Healthy
0=Active
. =Tamper or not Present
Zone Status
This option allows the current status of all iD devices to be
viewed on a single screen.
Print Log
Engineer Utils
Print Log
YES to Select:-
Engineer Utils
Yes
Engineer Utils
View Event Log
Yes
Print Log
> 050 <
Print Log
> 150 <
Yes
Enter number of events to print
(Maximum 250)
Press YES to start
This option allows up to 250 events to be printed to a serial
printer connected to com port 1.