Premier 24 Installation Manual Programming the Control Panel
INS248 83
Configure Radio
Engineer Utils
Configure Radio
Menu
No
23: ID242900 OK
SL:085 Zone>00
YES to Select:-
Engineer Utils
Yes
Engineer Utils
View Event Log
23: ID000000 OK
SL:000 Zone 00
Yes
??
Yes
Press YES to learn
Radio Device
23: ID242900 OK
SL:085 Zone>14
23: ID242900 OK
SL:085 Zone 14
??
Use keys 0 - 9 to enter the
required device number or
use the SCROLL key to search
e.g. 23 = Device 23
Press NO to map the
device to a zone/user
Use keys 0 - 9 to enter the
required zone/user number or
use the SCROLL key to search
e.g. 14 = Zone 14
Yes
01: ID000000 OK
SL:000 Zone 00
23: ID...... TAMP
Activate Device
Activate the Tamper
on the Device or press
Dissarm on the FOB
23: ID242900 OK
SL:085 Zone 00
Top Line = Serial number
of device
Bottom
and status
Line = Signal strength
and zone/user number
The Intelligent Radio Receiver or Network Receiver
provide the facility to use wireless detection devices and
Fobs. Up to 32 wireless devices can be connected,
including upto 24 detection devices and up to 16 fobs
(combined total cannot exceed 32 devices).
Wireless devices can then be mapped on to the system
along with conventional detectors.
The top line on the display shows the serial number of the
device and also the status i.e. Active, Tamper etc.
The bottom line of the display shows the signal strength
and also which zone/user the device is mapped to.
!
Signal strength should be greater than 30.
The signal range is between 0 and 90.
See Radio-Plus installation manual for full details
To Next Page
Loading...
