Texecom Premier 24 - Setting the System Date; To set the System Date, proceed as follows

Premier 24 Installation Manual Programming the Control Panel
INS248 39
5.2 Arming Options
Timers
H73!:0!3$-$6:TU
.)/589!@D:508<
Yes
Yes
.)/589!@D:508<
"5/$)<
Yes
Enter a new timer value
e.g. 025 = 25 Seconds
???
No
Press NO to
edit the timer
7P5:!B$-(=
!!!!\!%]%!^
7P5:!B$-(=
!!!!\!%]%!^
78:)=!+!B$-(=
!!!!\!%*_!^
78:)=!+!B$-(=
!!!!\!%*%!^
Press YES or SCROLL
to select the required
timer e.g. YES
Yes
There are 8 timers that control timing and delay functions.
Each timer can be programmed for any value between 000
and 255.
1 - Exit Delay
When the exit mode is programmed as ‘Timed’ this timer
controls the delay between the user initiating the exit mode
for the system actually arming (Default = 030 Seconds).
2 - Entry 1 Delay
If the system is armed and an ‘Entry/Exit 1’ zone is
activated, this timer will start and the entry tone will be
heard. If the system is not disarmed before this timer
expires, the ‘2
nd
Entry Dly’ timer will start. (Default = 015
Seconds).
3 - Entry 2 Delay
If the system is armed and an ‘Entry/Exit 2’ zone is
activated, this timer will start and the entry tone will be
heard. If the system is not disarmed before this timer
expires, the ‘2
nd
Entry Delay’ timer will start. (Default = 030
Seconds).
4 - 2
nd
Entry Dly
When the ‘Entry Delay 1 or 2’ timer expires, this timer will
start and an Internal alarm will occur. If the system is still not
disarmed before this timer expires, an Intruder alarm will
then occur (Default = 000 Seconds).
5 - Bell Delay
This timer controls the delay between an Intruder alarm
occurring and the ‘Bell/Strobe’ output activating (Default =
000 Minutes).
6 - Bell Duration
This timer controls the duration of the ‘Bell’ output after an
Intruder alarm has occurred and any programmed ‘Bell Delay’
has expired (Default = 015 Minutes).
7 - Coms Delay
This timer controls the delay between an Intruder alarm
occurring and the communicator reporting to the Alarm
Receiving Centre (Default = 000 Seconds).
8 - Part Bell Dly.
When the system is ‘Part Armed’ this timer controls the
delay between an Intruder alarm occurring and the
‘Bell/Strobe’ output activating, the internal sounders will also
sound during this time as a warning (Default = 000
Minutes).