Premier 48, 88 & 168 Installation Manual The Programming Menu
INS248 31
5. Programming the Control Panel
Introduction
All engineers should read this section carefully so as to
familiarise themselves with the programming of the control panel.
To access the Programming menu, enter the factory
default Engineer code
#$%"
.
If a mistake is made whilst entering the Engineer code, simply
re-enter the correct code.
WARNING
When an Engineers code is entered to gain
access to the Programming menu, by default
ALL zones and tampers are disabled.
The Strobe output will also pulse 3 times,
invoking Engineers Hold Off mode if a
Texecom bell box is connected.
A menu option can then be selected by pressing one of the
keys shown or by using the
&
key to search. Once
selected, press YES to access that option.
To leave the selected menu option and return to the main
programming menu, press
-
.
To exit from the Main Programming menu but still remain
‘Logged’ onto the system (zones and tampers still
disabled), press
-
and the display will show ‘Alarm
Engineer Working On Site’.
To log the Engineer off the system, press
'
followed by
YES and the system will revert to its normal condition.
The table below shows the menu options available:
Key Menu Option Page
#,
Zone Setup 34
$,
Arming Options 39
%,
Global Options 43
",
Keypad Setup 50
(,
Expander Setup 52
),
System Outputs 53
*,
UDL/Digi Options 60
+,
Setup Users 72
.,
Engineer Utils 77
/,
Alter Part Arms 84
!,
The Arming Menu -
',
Log Off Engineer 33
-,
Exit programming mode 33
Enter Engineers Code
!!
3(:!%+!S(8!*%%%
H73!:0!3$-$6:TU
3$:#D!V<$)<
8
tuv
H73!:0!3$-$6:TU
To Next Page
Loading...
