Shows the SATA hard disk capacity.
Displays the SATA hard disk model name.
Shows the SATA hard disk firmware version.
Yes to start scan Bad Block.
S.M.A.R.T. Information
On the Disk Information screen, select a disk then click on “Smart” to list the
S.M.A.R.T. info of the associated disk.
You may also perform a disk SMART test (doesn’t apply to SAS HDD); simply click
“Test” to start the SMART test. The result is only for reference and the system will
not take any action from its results.
Tray the hard disk is installed in.
Model name of the installed hard disk.
Count of hours in power-on state. The raw value of this attribute
shows total count of hours (or minutes, or seconds, depending on
manufacturer) in power-on state.
The current temperature of the hard disk in degrees Celsius.
Count of reallocated sectors. When the hard drive finds a
read/write/verification error, it marks this sector as "reallocated"
and transfers data to a special reserved area (spare area).
This process is also known as remapping and "reallocated"
To Next Page
Loading...
Need help?
General
Weight and Dimensions
