After your changes have been made, click Apply to confirm any modifications.
Once changes are applied, the associated information will be updated on the Stack
Target List window.
D. Stack Target ACL
If the stack target Public setting set to Yes, then the ACL button will be grayed out.
However, if Public setting is set to No, then the ACL button will be available for
you to setup user access permissions for the stack target.
The ACL settings will be exactly the same as the system folder that you may have
setup previously.
E. Reconnect a Stack Target
This is used to enable stack target devices that may have been disconnected due to
a power outage or a disconnected network. When this happens, the Reconnect
button will become available. To attempt to reconnect the stack target, click
Reconnect.
To Next Page
Loading...
