CUTMASTER 60i
Manual 0-5475 INSTALLATION
3-3
3.05 Primary Input Power Connections, THREE Phase
WARNING
Each CutMaster 60i system is a dedicated 1 Phase OR 3 Phase
system and cannot be reconfigured to the other. Personal injury
could occur if changing the phase is attempted..
!
CAUTION
The primary power source, fuse, and any extension cords used must
conform to local electrical code and the recommended circuit protec-
tion and wiring requirements as specified in Section 2.
Line
GND
Three-Phase (3ø)
Power
Cord
Power Switch
Three Phase Input Power Wiring
NOTE!
As long as the power supply is connected to
input power ranging from 208 VAC to 480
VAC, the system will automatically detect
this and run accordingly.
To Next Page
Loading...
Need help?
General
