Thermal Dynamics CUTMASTER 60i - General Maintenance and Schedule

CUTMASTER 60i
Manual 0-5475 SERVICE
5-1
SECTION 5 SYSTEM:
SERVICE
5.01 General Maintenance
Warning!
Disconnect input power before maintaining.
Each Use
Visual check of
torch tip and electrode
Weekly
Visually inspect the torch body,
consumables and Quick Connect
Visually inspect the
cables and leads.
Replace as needed
3 Months
Clean
exterior
of power supply
Replace all
broken parts
Maintain more often
if used under severe
conditions
6 Months
Visually check and
Carefully clean the
interior
Art# A-13084_AB