50
APPENDIX A: PIPE SCHEDULES
This appendix provides pipe schedules as a convenient reference for the following pipe materials: steel,
stainless steel, and PVC (Table A-1); cast iron (Table A-2); ductile iron (Table A-3).
The inside diameters (IDs) listed in the following tables are calculated from the outside diameter (OD) and
minimum wall thicknesses as specified in applicable standards. The actual pipe ID may vary from the
dimension listed in the tables by as much as 25% of the pipe minimum wall thickness. The accuracy of
flow rate measurement is enhanced if the pipe ID is actually measured.
To Next Page
Loading...
