Thomas 95 User Manual

2-19
2
TANDEM PUMP REPLACEMENT 2.10
Installation (continued)
9 Reinstall the steering control linkages as outlined in
Section 4. (fig. C2443).
10 Fill the hydraulic oil reservoir to the proper level.
11 Follow the start up procedure outlined in section 2.8
before attempting to start the loader.
12 Start the loader and check for leaks. Make repairs as
necessary and replenish the hydraulic oil reservoir. Never
use your hands to check for hydraulic leaks.
13 Make adjustments to the steering controls as
required. Follow the procedures for control adjustments
in Section 4.
C2443
C2347
C2354
Fill level
Reservoir sight gauge
Hydraulic reservoir filler cap
Replace control linkage
IMPORTANT
Follow the start up procedure outlined in section 2.8
upon restarting after pump repairs or replacement.
WARNING
This start-up procedure must be made with the
loader securely raised off the ground. Changing the
pumps and the steering control linkages has affect-
ed the neutral adjustment. Failure to raise the
loader clear of the ground may result in the loader
engaging in motion and possibly causing serious
injury.
WARNING
To prevent personal injury never make repairs to
the hydraulic system while the engine is operating.
Use caution when dealing with hydraulic fluid
under pressure. Escaping fluid under pressure can
penetrate the skin and cause serious injury.

Thomas 95 Specifications

General

Brand	Thomas
Model	95
Category	Compact Loader
Language	English