THORLABS DC2200 - Page 57

© 2020 Thorlabs GmbH
4 Write Your Own Application
55
Error
Description
250
Unable to switch operating mode while LED output is on
251
A stored value is out of bounds and has been coerced
252
Empty storage - push and hold button to store setpoints
253
Setpoints stored
260
Unable to leave panel while LED output is on (safety mode)
261
Unable to switch LED output on in menu panel (safety mode)
270
No LED connected
271
Unknown LED head type
272
LED head memory data invalid
273
LED head memory version not supported
274
A mandatory LED head feature is not supported by the device
275
The forward voltage required by the LED head is not supported by the device. Occurrence of LED OPEN
is highly possible
276
The maximum forward current allowed by the LED head can't be reached by the device
277
Can not assign LED head memory to terminals
278
The head data does not fit into the EEPROM
301
1-Wire line is shorted
302
No 1-Wire device found
304
No 1-Wire device on net
305
1-Wire bridge reset bit RST is set
307
1-wire file system: can't find path
308
1-wire file system: can't open file
309
1-wire file system: can't read file
310
1-wire file system: can't close file
312
Invalid 1-wire device handle
313
Invalid 1-wire device address
320
Invalid 1-Wire bridge channel
321
Invalid 1-Wire bridge index
-100
General command error