© 2016 Thorlabs26
ITC8000
Setting the main parameters
To set the main parameters in the main menu, select the corresponding module (here CH1) with
the cursor:
Pressing the key (TUNE) will turn the cursor pointing now to the right. Press the soft key ILD to
adjust the laser set current by means of the tuning knob.
Press the soft key Ts to adjust the set temperature by means of the tuning knob:
Pressing the key completes the procedure.
Note
If the TEC current is switched ON, the actual temperature is displayed. In this case the set
temperature can still be changed but is not displayed.