© 2016 Thorlabs66
ITC8000
9.2 Certifications and Compliances
EC Declaration of
Conformity - EMC
Meets intent of Directive 2004/108/EC
1
for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EMC requirements for Class A electrical equipment for measurement,
control and laboratory use,
including Class A Radiated and Conducted Emissions
2,3,4
and
Immunity
2,3,5
Electrostatic Discharge Immunity (Performance Criterion C)
Radiated RF Electromagnetic Field Immunity (Performance Criterion B)
Electrical Fast Transient / Burst Immunity (Performance Criterion C)
Power line Surge Immunity (Performance criterion C)
Conducted RF Immunity (Performance Criterion B)
Voltage Dips and Interruptions Immunity (Performance Criterion C)
AC Power Line Harmonic Emissions
Australia / New
Zeeland
Declaration of
Conformity - EMC
Complies with the Radiocommunications Act and demonstrated per EMC Emission standard
2,3,4
Industrial, Scientific, and Medical Equipment: 1992
Emissions comply with the Class A Limits of FCC Code of Federal Regulations 47, Part 15,
Subpart B
2,3,4
.
1
Replaces 89/336/EEC.
2
Compliance demonstrated using high-quality shielded interface cables, including with CAB4x series cables installed at the LD OUT and
TEC OUT ports. ITC8022 testing included a LAB8000 Laser Diode Mount Box attached at the other end of the CAB4x cable.
3
Compliance demonstrated w ith the ITC8000 Series modules installed in the Thorlabs PRO8xxx Series Mainframes.
4
Emissions, w hich exceed the levels required by these standards, may occur w hen this equipment is connected to a test object.
5
Minimum Immunity Test requirement.
9.3 Literature
[1] IEEE488.2-1992 - IEEE Standard Codes, Formats, Protocols, and Common Commands for
Use With IEEE Std 488.1-1987, IEEE Standard Digital Interface for Programmable
Instrumentation
Available at http://www.ieee.org/publications_standards/index.html .