EasyManuals Logo

THORLABS ITC8000 User Manual

THORLABS ITC8000
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
© 2016 Thorlabs48
ITC8000
7.3.22 Thermistor Calibration - Exponential Method
Command
Explanation
Response Example
Programming
":CALTB:SET <NR3>"
Programs the energy constant Bval
":CALTR:SET <NR3>"
Programs the nominal resistance R0
":CALTT:SET <NR3>"
Programs the nominal temperature T0
Reading
":CALTB:SET?"
Reads the energy constant Bval
[:CALTB:SET <NR3><LF>]
":CALTR:SET?"
Reads the nominal resistance R0
[:CALTR:SET <NR3><LF>]
":CALTT:SET?"
Reads the nominal temperature T0
[:CALTT:SET <NR3><LF>]
":CALTB:MIN?"
Reads the minimum allowed energy constant Bval
[:CALTB:MIN <NR3><LF>]
":CALTR:MIN?"
Reads the minimum allowed nominal resistance R0
[:CALTR:MIN <NR3><LF>]
":CALTT:MIN?"
Reads the minimum allowed nominal temperature T0
[:CALTT:MIN <NR3><LF>]
":CALTB:MAX?"
Reads the maximum energy constant Bval
[:CALTB:MAX <NR3><LF>]
":CALTR:MAX?"
Reads the maximum allowed nominal resistance R0
[:CALTR:MAX <NR3><LF>]
":CALTT:MAX?"
Reads the maximum allowed nominal temperature T0
[:CALTT:MAX <NR3><LF>]
Refer to section Thermistor Calibration - Exponential Method .
Attention
These commands do not apply to ITC8000-KRYO!
Note
The selection by which method (exponential or Steinhart-Hart) the sensor calibration will be
executed, depends on the order in which the coefficients are transmitted:
· If the last transmitted calibration command belongs to the exponential method (see above),
then the calculation is also done with the exponential method.
· If the last command was a Steinhart-Hart parameter, then this method is selected.
48

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS ITC8000 and is the answer not in the manual?

THORLABS ITC8000 Specifications

General IconGeneral
BrandTHORLABS
ModelITC8000
CategoryTemperature Controller
LanguageEnglish

Related product manuals