THORLABS ITC8000 - Programming the Temperature (TEMP)

© 2016 Thorlabs
7 Communication with a PC
45
7.3.17 Programming the Temperature (TEMP)
Command
Explanation
Response Example
Programming
":TEMP:SET <NR3>"
Programs the set temperature
":TEMP:MEAS <NR1>"
Programs TEMP to be the measurement value for “ELCH
1
)” on
position <NR1> (1...8) in the output string.
Reading
":TEMP:SET?"
Reads the set temperature
[:TEMP:SET <NR3><LF>]
":TEMP:ACT?"
Reads the actual temperature
[:TEMP:ACT <NR3><LF>]
":TEMP:MIN?"
Reads the minimum allowed set temperature
[:TEMP:MIN <NR3><LF>]
":TEMP:MAX?"
Reads the maximum allowed set temperature
[:TEMP:MAX <NR3><LF>]
":TEMP:MIN_W?"
Reads T - DAC = 0000
[:TEMP:MIN_W <NR3><LF>]
":TEMP:MAX_W?"
Reads T - DAC = FFFF
[:TEMP:MAX_W <NR3><LF>]
":TEMP:MIN_R?"
Reads T - ADC = 0000
[:TEMP:MIN_R <NR3><LF>]
":TEMP:MAX_R?"
Reads T - ADC = FFFF
[:TEMP:MAX_R <NR3><LF>]
":TEMP:MEAS?"
Reads the position of TEMP as measurement value in the
“ELCH” output string (1....8, 0 if not selected)
[:TEMP:MEAS <NR1><LF>]
1
) ELectrical CHaracterization