THORLABS ITC8000 User Manual

306.3.6 Selecting Constant Current or Constant Power Mode
306.3.7 Selecting the Type of the Temperature Sensor
306.3.8 Thermistor Calibration
326.3.9 Temperature Window
326.3.10 Setting the P, I and D Share of the Control Loop
326.4 Switching ON and OFF
346.5 Error Messages
7 Communication with a PC 36
367.1 Nomenclature
367.2 Data Format
377.3 Commands and Queries
377.3.1 Select the Module Slot (SLOT)
377.3.2 Query Type of Module (TYPE)
377.3.3 Selecting the Photo Diode Polarity (PDPOL)
377.3.4 Selecting the Operation Mode (MODE)
387.3.5 Programming the BIAS Voltage (VBIAS)
387.3.6 Selecting the Laser Diode Polarity (LDPOL)
397.3.7 Reading the Laser Diode Hardware Limit (LIMCP)
397.3.8 Programming the Laser Diode Software Limit (LIMC)
407.3.9 Setting the Laser Diode Current (ILD)
417.3.10 Setting the Monitor Diode Current (IMD)
427.3.11 Calibrating a Photodiode (CALPD)
427.3.12 Programming the Optical Power (POPT)
437.3.13 Activating the Temperature Protection (TP)
437.3.14 Switching the Laser Output On and Off (LASER)
447.3.15 Reading the Laser Diode Voltage (VLD)
447.3.16 Programming the TEC Current Software Limit (LIMT)
457.3.17 Programming the Temperature (TEMP)
467.3.18 Programming the Temperature Window (TWIN)
467.3.19 Programming the Resistance Window (RWIN)
477.3.20 Selecting the Sensor (SENS)
477.3.21 Programming the Resistance of the Temperature Sensor (RESI)
487.3.22 Thermistor Calibration - Exponential Method
497.3.23 Thermistor Calibration - Steinhart-Hart Method
507.3.24 Programming the PID Shares (SHAREP, SHAREI, SHARED)
507.3.25 Switching the I Share On / Off (INTEG)
517.3.26 Switching the TEC On / Off (TEC)
517.3.27 Reading the TEC Current (ITE)
527.3.28 Reading the TEC Voltage (VTE)
537.4 IEEE Error Messages
557.5 Status Reporting
587.5.1 Standard Event Status Register (ESR)

THORLABS ITC8000 Specifications

General

Brand	THORLABS
Model	ITC8000
Category	Temperature Controller
Language	English